placestats

Poverty rate (model-based) and Economic connectedness

Where Poverty rate (model-based) is higher, Economic connectedness tends to be lower. The link is moderate: -0.47 across 3,011 counties, on a scale from −1 (opposite) to +1 (in step). That figure compares places with the same population density, income and education, so those differences can't explain it. It holds inside states too. Measured separately within each of 40 states, the middle value of the link is -0.73.

Holds after adjusting

Every place, plotted

One dot for each place reporting both measures. Hover over or tap a dot to see its name and values. The thin line is the straight line that best fits the dots. The bold line, shown for counties, is the link after adjusting for density, income and education. A dot far from the lines is a place that does not follow the pattern.

Loading every place…

What each measure is

Poverty rate (model-based)

The percentage of people in poverty, as an estimate from a statistical model, not a direct count. The Census Bureau combines survey answers with tax and food-assistance records, to get figures that small counties' survey answers cannot give on their own.

Census SAIPE · Census SAIPE SAEPOVRTALL_PT

Economic connectedness

How many of a low-income person's friends are high-income, compared with an even mix. One means their friends match the local mix of rich and poor. Below one means their friendships are more divided by income than that.

Social Capital Atlas · Opportunity Insights ec_county

Highest and lowest

Where each measure is highest and lowest among the places reporting both (2023), with the other measure beside it. This is shown for every size of place where both are published. Metro-area values are added up from their counties. A measure that cannot be added up across counties, such as a middle value (median), has no metro figure. Counts are shown per 1,000 residents, since raw totals would only list the largest places. Cities and towns and ZIP codes are shown where the Census survey or the CDC publishes them; most other sources stop at the county. They are shown for places of 5,000 residents or more, and only where the survey’s margin of error is small enough for the figure to be usable. The CDC publishes its health estimates for cities in a version adjusted for age, so places with older or younger people can be compared fairly, but not for ZIP codes.

Counties

By poverty rate (model-based)

Poverty rate (model-based)Economic connectedness
Highest
Martin County, KY48.1%0.689
East Carroll Parish, LA46.5%0.427
Bolivar County, MS38.7%0.555
Lee County, AR38.7%0.529
Crowley County, CO37.5%0.759
Lowest
Lincoln County, SD3.3%1.16
Douglas County, CO3.7%1.35
Los Alamos County, NM3.8%1.12
Loudoun County, VA4.1%1.22
Morgan County, UT4.3%1.29

By economic connectedness

Poverty rate (model-based)Economic connectedness
Highest
Rockingham County, NH5.4%1.36
Douglas County, CO3.7%1.35
San Francisco County, CA11.9%1.31
Morgan County, UT4.3%1.29
Madison County, ID20.6%1.28
Lowest
Todd County, SD35.6%0.295
Oglala Lakota County, SD37.1%0.33
Terrell County, GA28.1%0.347
Bullock County, AL33.6%0.355
Allendale County, SC32.6%0.361
States — Economic connectedness is not published for states

By poverty rate (model-based)

Poverty rate (model-based)Economic connectedness
Highest
Louisiana18.9%—
Mississippi18.3%—
New Mexico16.9%—
West Virginia16.4%—
Kentucky16.1%—
Lowest
New Hampshire7.3%—
Utah9%—
Minnesota9.2%—
Colorado9.4%—
New Jersey9.7%—
Metro areas

By poverty rate (model-based)

Poverty rate (model-based)Economic connectedness
Highest
Cleveland, MS38.7%0.555
Greenville, MS35.5%0.463
Forrest City, AR34.3%0.531
Gallup, NM34.3%0.416
Selma, AL31.4%0.455
Lowest
Los Alamos, NM3.8%1.12
Heber, UT5.05%1.06
Appleton, WI5.93%1.04
Jackson, WY-ID6.34%1.05
Nantucket, MA6.5%0.694

By economic connectedness

Poverty rate (model-based)Economic connectedness
Highest
Provo-Orem-Lehi, UT8.99%1.22
Alexandria, MN8.7%1.18
Laramie, WY16.7%1.17
Hutchinson, MN7.9%1.16
Ames, IA13.4%1.15
Lowest
Lumberton, NC27.7%0.363
Cordele, GA26%0.388
Laurinburg, NC28.6%0.396
Eufaula, AL-GA25.3%0.414
Gallup, NM34.3%0.416

Counties furthest from the pattern

Compared with the straight line that best fits all 3,020 counties: the five with far more economic connectedness than their poverty rate (model-based) would suggest, and the five with far less.

Poverty rate (model-based)Economic connectedness
Above the line
Martin County, KY48.1%0.689
Madison County, ID20.6%1.28
Whitman County, WA24.8%1.14
Crowley County, CO37.5%0.759
San Francisco County, CA11.9%1.31
Below the line
Saluda County, SC16.1%0.412
Colfax County, NE9.7%0.573
Mercer County, NJ10.6%0.567
Chatham County, NC8.4%0.638
Jerome County, ID12.3%0.559

Two series, one county

Both measures over time for a county you pick. The two charts are stacked, so they share only the years along the bottom. You can pick from the thirty largest counties reporting both. This panel covers 2010–2024, and a measure published only once shows as a single dot.

Loading…

Every version of the link

Each row measures the same link, from −1 to +1, in a different way. If the rows mostly agree, the link does not depend on one choice of method.

Before adjusting for anything-0.7073,011 counties reporting both
After adjusting for density, income and education-0.472the part of the link that is not just how urban, rich and educated a place is
Also adjusting for population size-0.466size taken out as well as density
Also comparing only within each state-0.422each county is compared only with others in its own state, so this is no longer a comparison between states
Giving bigger counties more weight-0.290the adjusted link for the average resident rather than the average county. With this weighting, the data counts for about 286 equally weighted counties
Middle value inside single states-0.727the link worked out inside each of 40 states with at least 20 counties reporting
Using ranks, after adjusting-0.443uses each county’s rank, not its value, so a few extreme counties cannot create the link

How much to believe it

Could it be chance?

The p-value is the chance of seeing a link this strong if there were really none. A value of 0.05 or less means the link is unlikely to be chance. Very small values are written in short form: 3.1e-16 means 0.00000000000000031, and the bigger the number after “e-”, the smaller the value. Treating every county as a separate case gives p = 1.3e-166. But counties in the same state tend to resemble each other, so the better figure allows for that: p = 5.3e-9. The site tested 20,910 pairs, and testing so many turns up some flukes. The q-value allows for that too. For this pair it is 1.4e-165.

Do nearby places look alike?

Moran’s I measures how much nearby places look alike: 0 means no map pattern, and higher means neighbours are more similar. For the part of each county that the adjustment leaves unexplained, it is +0.49 (p = 0.001). That unexplained part still clusters on the map. So some regional factor shared by both measures is not accounted for.

Did they change together?

Not measurable: at least one of these is published for too few of the years a change needs (2014–2019 or 2019–2023), or for too few counties in both.

Related pairs

Association only. Nothing here shows that either measure changes the other. This describes counties, not the people in them. Two measures going together across places does not mean the same people have both. How the US county data works · Explore Poverty rate (model-based) and Economic connectedness