placestats

Total population and Robbery rate

Where Total population is higher, Robbery rate tends to be higher. The link is weak: +0.33 across 2,281 counties, on a scale from −1 (opposite) to +1 (in step). That figure compares places with the same population density, income and education, so those differences can't explain it. It holds inside states too. Measured separately within each of 36 states, the middle value of the link is +0.69.

Holds after adjusting

Every place, plotted

One dot for each place reporting both measures. Hover over or tap a dot to see its name and values. The thin line is the straight line that best fits the dots. The bold line, shown for counties, is the link after adjusting for density, income and education. A dot far from the lines is a place that does not follow the pattern.

Loading every place…

What each measure is

Total population

How many people live here, as counted by the American Community Survey. This comes from the survey, not from the Census Bureau's separate population estimates.

Census ACS 5-year · ACS table B01003_001

Robbery rate

Robberies in the year, per 100,000 residents, from the FBI. A robbery is taking something from a person by force or by threat, such as a mugging. It counts only crimes reported to police or found by them, so crimes nobody reports are missing. For a state, the figure is the FBI's estimate, which fills in for police agencies that did not report. For a county, it is only what the agencies reported, and it is shown only where agencies that reported for all 12 months serve at least 90% of the people who live there.

FBI Uniform Crime Reporting program (Crime Data Explorer) · FBI Crime Data Explorer: states, estimated_crimes robbery; counties, Return A master file, actual offenses

Highest and lowest

Where each measure is highest and lowest among the places reporting both (2023), with the other measure beside it. This is shown for every size of place where both are published. Metro-area values are added up from their counties. A measure that cannot be added up across counties, such as a middle value (median), has no metro figure. Counts are shown per 1,000 residents, since raw totals would only list the largest places. Cities and towns and ZIP codes are shown where the Census survey or the CDC publishes them; most other sources stop at the county. They are shown for places of 5,000 residents or more, and only where the survey’s margin of error is small enough for the figure to be usable. The CDC publishes its health estimates for cities in a version adjusted for age, so places with older or younger people can be compared fairly, but not for ZIP codes.

Counties

By total population

Total population, per 1,000 residentsRobbery rate
Highest
Fresno County, CA1000.05117
Daviess County, KY1000.0524.2
Bay County, MI1000.0516
Maury County, TN1000.0523
Lowndes County, GA1000.0448.9
Lowest
Lancaster County, SC999.9517
Allen County, OH999.9529.3
Pima County, AZ999.9560.4
Flathead County, MT999.9512.2
Ontario County, NY999.9611.3

By robbery rate

Total population, per 1,000 residentsRobbery rate
Highest
District of Columbia, DC1000.00625
Baltimore city, MD999.99584
Alameda County, CA999.97371
San Francisco County, CA1000.00361
Philadelphia County, PA999.98339
Lowest
Washington County, CO1000.000
San Miguel County, CO1000.000
San Juan County, CO1000.000
Saguache County, CO1000.000
Phillips County, CO1000.000
States

By total population

Total population, per 1,000 residentsRobbery rate
Highest
Michigan1000.0436.9
Pennsylvania1000.0462.8
Georgia1000.0444.6
Delaware1000.0352.4
Rhode Island1000.0321.9
Lowest
North Carolina999.9751.8
Hawaii999.9749.6
New Hampshire999.9816.6
Nebraska999.9826.4
New York999.98105

By robbery rate

Total population, per 1,000 residentsRobbery rate
Highest
District of Columbia1000.00607
Maryland999.99131
California1000.01128
Illinois1000.02110
New York999.98105
Lowest
Idaho1000.009.39
West Virginia1000.0211.4
Wyoming1000.0011.6
Maine1000.0011.7
Vermont999.9914.6
Metro areas

By total population

Total population, per 1,000 residentsRobbery rate
Highest
Town of Pecos, TX1123.118.26
Big Spring, TX1084.2127.1
Susanville, CA1080.2538.1
Selma, AL1037.9149.8
Gallup, NM1034.5283.1
Lowest
Wildwood-The Villages, FL907.475.1
Jefferson, GA910.006.35
Myrtle Beach-Conway-North Myrtle Beach, SC928.2036.3
Lakeland-Winter Haven, FL929.8923.1
Cedar City, UT937.554.64

By robbery rate

Total population, per 1,000 residentsRobbery rate
Highest
San Francisco-Oakland-Fremont, CA1018.97235
Memphis, TN-MS-AR1004.44234
Stockton-Lodi, CA983.09194
Philadelphia-Camden-Wilmington, PA-NJ-DE-MD999.32178
Pueblo, CO995.92166
Lowest
Zapata, TX1008.660
Yankton, SD994.130
Waterloo-Cedar Falls, IA999.990
Warren, PA1016.020
Urbana, OH998.120
Cities and towns — Robbery rate is not published for cities and towns

By total population

Total population, per 1,000 residentsRobbery rate
Highest
San Mateo city, CA1000.05—
Inglewood city, CA1000.05—
Sugar Land city, TX1000.05—
Manchester city, NH1000.04—
Clearwater city, FL1000.04—
Lowest
Lynn city, MA999.95—
Vacaville city, CA999.95—
Burbank city, CA999.95—
Green Bay city, WI999.95—
Ponce zona urbana, PR999.95—
ZIP codes — Robbery rate is not published for ZIP codes

By total population

Total population, per 1,000 residentsRobbery rate
Highest
ZIP 37013 (Nashville-Davidson metropolitan government (balance), TN)1000.05—
ZIP 77084 (Houston city, TX)1000.05—
ZIP 79936 (El Paso city, TX)1000.03—
ZIP 78660 (Pflugerville city, TX)1000.03—
ZIP 90650 (Norwalk city, CA)1000.02—
Lowest
ZIP 11385 (New York city, NY)999.95—
ZIP 90011 (Los Angeles city, CA)999.96—
ZIP 08701 (Ocean County, NJ)999.97—
ZIP 92336 (Fontana city, CA)999.97—
ZIP 77494 (Fort Bend County, TX)999.98—

Counties furthest from the pattern

Compared with the straight line that best fits all 2,289 counties: the five with far more robbery rate than their total population would suggest, and the five with far less.

Total population, per 1,000 residentsRobbery rate
Above the line
District of Columbia, DC1000.00625
Baltimore city, MD999.99584
Alameda County, CA999.97371
San Francisco County, CA1000.00361
Philadelphia County, PA999.98339
Below the line
Washington County, RI999.980.763
Allegan County, MI999.981.55
Washington County, CO1000.000
San Miguel County, CO1000.000
San Juan County, CO1000.000

Two series, one county

Both measures over time for a county you pick. The two charts are stacked, so they share only the years along the bottom. You can pick from the thirty largest counties reporting both. This panel covers 2010–2024, and a measure published only once shows as a single dot.

Loading…

Every version of the link

Each row measures the same link, from −1 to +1, in a different way. If the rows mostly agree, the link does not depend on one choice of method.

Before adjusting for anything+0.4582,281 counties reporting both
After adjusting for density, income and education+0.325the part of the link that is not just how urban, rich and educated a place is
Also adjusting for population size+0.267size taken out as well as density
Also comparing only within each state+0.267each county is compared only with others in its own state, so this is no longer a comparison between states
Giving bigger counties more weight+0.329the adjusted link for the average resident rather than the average county. With this weighting, the data counts for about 227 equally weighted counties
Middle value inside single states+0.690the link worked out inside each of 36 states with at least 20 counties reporting
Using ranks, after adjusting+0.399uses each county’s rank, not its value, so a few extreme counties cannot create the link

How much to believe it

Could it be chance?

The p-value is the chance of seeing a link this strong if there were really none. A value of 0.05 or less means the link is unlikely to be chance. Very small values are written in short form: 3.1e-16 means 0.00000000000000031, and the bigger the number after “e-”, the smaller the value. Treating every county as a separate case gives p = 3.7e-57. But counties in the same state tend to resemble each other, so the better figure allows for that: p = 3.0e-6. The site tested 29,403 pairs, and testing so many turns up some flukes. The q-value allows for that too. For this pair it is 2.6e-56.

Do nearby places look alike?

Moran’s I measures how much nearby places look alike: 0 means no map pattern, and higher means neighbours are more similar. For the part of each county that the adjustment leaves unexplained, it is +0.21 (p = 0.001). That unexplained part still clusters on the map. So some regional factor shared by both measures is not accounted for.

Did they change together?

The figures above compare counties at one moment. This asks a different question: where total population rose most, did robbery ratemove too? Each county’s change is compared with the average change in its own state. That takes out ups and downs that hit a whole region at once. Each change is the gap between two estimates that both contain some error. That error pulls these links towards zero, so a weak one is weak partly for that reason. The q column shows whether a link could be a fluke, allowing for the many pairs tested: 0.05 or less means it is unlikely to be chance.

PeriodCountiesChange togetherWithin statesq
2014–2019 the main test: each Census survey figure averages five years, and these two do not overlap; before the pandemic2,020-0.08-0.070.029
2019–2023 a repeat check: its two five-year survey figures both include 2019, and it covers the COVID years1,883-0.00-0.030.540

In counties where one changed more, the other tended to move the opposite way, compared with other counties in the same state (r = -0.07). It does not hold clearly in the second period, which spans the pandemic. How change is measured.

Related pairs

Association only. Nothing here shows that either measure changes the other. This describes counties, not the people in them. Two measures going together across places does not mean the same people have both. How the US county data works · Explore Total population and Robbery rate